This Power Distribution Board has an input voltage of 9-18V allowing it to run off a 3 or 4s LiPo battery. Along with this, it comes with a lot of the features that are familiar with the Matek produced PDBs with the regulated 5V BEC that can run at a constant 2A (Max 2.5A), a 12V BEC that can run at a constant 500mA (Max 800mA) and 6 pairs of ESC solder joints. This PDB with a built in XT-60 is built to the same high standard Matek are known for with 4 layers of PDB with 2oz copper and only 1.6mm thick.
This Matek PDB is built with the standard 36mmx36mm mounting holes and the width with the XT60 is 42mm. With the XT-60 it weighs in at 10.91 grams.
Item name: Matek PDB XT60
Dimensions: 36 x 36mm (42mm with the XT60 connection)
Weight: 10.91g (With the XT60)
Mounting holes: 30.5mm square spacing
2oz copper & 4-layers PCB.
ESC & Battery solder tabs in pairs.
DC/DC synchronous buck regulator, Efficiency is up to 95%.
5V & 12V Output LED indicators & Short circuit tolerant.
Input voltage range (3S-4S operation): 9 - 18VDC
Regulated 5V and 12V outputs
LED power indicators ( 5V & 12V outputs )
6 ESC outputs
Continuous current: 25A per output for 4 ESCs or 15A per output for 6 ESCs.
Peak current (10 seconds/minute): 30A per output for 4 ESCs or 20A per ESC for 6 ESCs
BEC 5V output:
Designed for RC Receivers, Flight controllers, OSD, and Servos.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 2 Amps
Short-circuit tolerant (5 seconds/minute)
BEC 12V output:
Voltage: 12.0 +/- 0.2VDC
Continuous current: 500mA (Max 800mA 5s/minute)
Short-circuit tolerant (10 seconds/minute)
The XT60 does not come pre-soldered so you will need to solder the XT60 to the PDB
$5.50 Regular Price