200, Jalan Sultan, #02-36A, Textile Centre, Singapore 199018 (Tel) : +65 62933968 / Operating Hours : (Mon-Fri 12pm-7pm) / (Sat & Eve of PH 12pm-6pm) / Sundays Close






Visit our Shopfront


Advance Drones > AstroX Q130 Frame (130mm)

(Motors & Electronics not included, Kit only!)

AstroX Q130 (Kit Only)
(Motors not included)

• Full 3K Carbon Fiber airframe (Base plate 2T / Round cut).
• AstroX Silky finish coated (All carbon parts - Carbon dust free).
• Frame size for 3" propellers, 130mm motor to motor.
• New 20mm Alu 6061 T6 standoff 4pcs and 22mm 1pcs.
• 12.9 Carbon Steel M3 screws (Black nickel plated).
• M3*6mm Nylon Standoff, nut and washer.
• New Silicone ring for FC
• Lipo strap small 190mm (2pcs).
• Designed under 22mm size cams (recommended camera : 14mm W x 14mm H size micro camera).
• Alu 6061 T6 camera mount for14mm x 14mm camera (wide FPV camera angle) • Super light weight and super rigid for racing

Speed around : 130km/H (4s)
Frame full setup weight : under 130g (Frame,FC,ESC,Motor,Reciever,Camera,VTX,Velcro strap,Ant) frame size : 130mm

Recommended set up:
• 3s-4s lipo battery.
• FX806T micro VTX and camera
• 4in1 20A ESC with 5V BEC (BEC for VTX and Camera)
• 30.5mm x 30.5mm hole standard size FC (BEC 5V for FC and Reciever)
• 1406 motor - 3500kv ~ 4000kv for 3s
• 1407-3500kv for 3s~4s
• HQ prop 3x3x3 PC prop

• 1 x 2mm carbon fiber unibody base plate (Round cut, Silky coated)
• 1 x 1.5mm carbon fiber top plate (Silky coated)
• 1 x 1.5mm x 2 side wall plate (Silky coated)
• 1 x 1.5mm Camera wall plate (Silky coated)
• 1 x Alu 6061 T6 Camera mount
• 1 set of 12.9 carbon steel screws (black nickel plated)
• 1 set of aluminum hardware (4x4mm and 1x22mm standoff)
• 1 set of nylon standoff, hex nut, and washers
• 1 set of Silicone ring for FC
• 2 x Lipo strap
• 1 x Lipo pad


This Kit is not suitable for beginners as it is not a ready-to-fly kit.
Assembly & Radio Setup required.

AstroX Q130
(Air Frame Only)